408-754-4176 | info@reachtech.com

by Reach Technology, a Novanta Company
PoE Test Equipment for Electronic Equipment Manufacturers > PoE4N/10G Power-over-Ethernet (IEEE 802.3af/at/UPoE/PoE++) Tester

PoE4N/10G Power-over-Ethernet (IEEE 802.3af/at/UPoE/PoE++) Tester

The PoE4N/10G supports 10G speeds (up to 10GBASE-T) and provides production testing of 24 PSE ports compatible with IEEE Standards 802.3af and 802.3at as well as proprietary UPoE and PoE++ implementations. It can draw over 600mA on up to two power pairs per port (over 60W per port) while passing 10Gb traffic. It provides high density with 24 Powered Device (PD) loads in a 1U high chassis. To reduce cost, the datapath of each UUT port is connected to its neighbor for loopback testing (port 1 – 2, 3 – 4, etc). Data traffic is either generated by the switch if it has a diagnostic ability, or externally and routed through each port by using the appropriate VLAN configuration.

Note: PoE4N/10G replaces PoE4N testers supporting 10G speeds and are 100% backward compatible. Contact Technical Support if you need legacy documentation.

Specification Highlights

  • IEEE Signature test.
  • IEEE Classification test.
  • Passes 10GbE traffic between PSE ports with isolated power drawn from each port.
  • Relay data path for compatibility with Phy-based cable diagnostics.
  • Low cost compared to compliance-level PD emulators.
  • Universal voltage (110/220) power supply.
  • Serial RS232 console control.



Pricing and Availability